The support-bridge module is a structural piece in Modu Drawer's modular system that lets modules stack into another layer above the first.
How the bridge works
The support bridge spans across lower pieces and provides a platform for another layer of modules. Upper modules connect to the matching grid pattern in the same slot-and-snap system used on the base.
Three layout checks matter:
- The planned lower arrangement must provide the support points required by the bridge.
- The drawer needs enough measured depth for the lower modules, bridge, upper modules, and contents.
- Choose the modules and contents for each layer using the applicable product information; no general load rating is claimed here.
Where another layer can help
- Cutlery drawers with extra depth. Separate everyday cutlery from less-frequently used serving pieces.
- Coffee station drawers. Organise pods, sachets, scoops, and stirrers across layers.
- Junk drawers. Keep frequently used items accessible while separating occasional items.
When stacking does not help
- Insufficient vertical clearance. If the complete planned stack does not fit below the lowest obstruction, use a single layer.
- No suitable bridge position. The bridge needs the support arrangement intended for that configuration.
- Tall lower-tier contents. Items that occupy the available stacking clearance leave no room for another layer.
Use the drawer builder to plan the length-and-width footprint, then check vertical clearance separately. See also drawer depth and stackable drawer organiser.